COMPACTWALL TR

FACADES AS ENERGY SOURCES

product guarantee
marked

simple.
minimalist.
efficient.

Innovation on the facade: We are expanding the COMPACTWALL family with our proven COMPACTMETAL TR-System. Solar energy can now also be used efficiently on sandwich facades.

With COMPACTWALL TR, we supply the tailor-made installation solution for generating energy from solar power on sandwich facades.

The extremely stable TR rail consolidates the loads caused by wind, suction and pressure forces and transfers them to the wall stanctions via the intelligent load transfer. Due to the vertical installation of the system, there are no snow loads, which means that only the low dead weight of the system is absorbed by the thin sheet metal screws. The sandwich core of the facade panels remains completely unaffected. Optimum load transfer is guaranteed for all spans of the wall stanctions. The raised rail design ensures optimum ventilation of the PV modules and is designed for high wind loads. This maximizes the performance and service life of the modules – without compromising on safety, quality or installation speed. In addition, long rails can be seamlessly integrated into the lightning protection system if required.

No additional load, no loss of warranty – gentle on the panel
Fewer penetration points – faster installation, maximum tightness
Direct force transmission into the substructure, regardless of the wall stanchion spacing

The sandwich drilling screw transfers the wind loads directly into the building structure. Suitable for timber and steel wall stanchions.
Patented load transfer via the screw heads of the sandwich drilling screw. The thin sheet screw absorbs the shear forces.
The load introduction via the stable TR rail enables module installation regardless of the span width.
The sandwich panel is not subjected to any additional load due to the direct force transmission into the building structure.

CLE20/CLM20 MODULE CLAMPS

The PV modules are attached using the universal click clamp with integrated earthing pins. The cross-system clamp is height-adjustable between 28 - 42 mm and can be easily clicked into place. The end clamp has a length of 60 mm. The clamps are also available in black.

TR59 rail

Used for reduced snow load. It is 15 mm lower than the TR74 rail.

TR74 Rail

Used for high wind and snow loads. It is 15 mm higher than the TR59 rail.

TR15/TR15S SANDWICH ROOF BASE

TR Self drilling screw

SP20 Spacer sleeve

MSS 6x25 Thin Sheet Screw

By using only self-tapping screws, the installation of the PV mounting system is fast, easy and efficient.

TR59 Rail connector

WCL8-10 wire clamp

The wire clamp ensures a secure, stable connection and high conductivity for integrating the system into the lightning protection system. They offer flexible application options and ensure long-term reliability and corrosion resistance.